Suntex Products

Category : [ Conductivity Transmitter ]

EC-4110-ICON Inductive conductivity Transmitter
Intelligence Advanced Graphics, RS-485 Modbus
Built-in concentration curve and user-defined concentration table
Decrease font size Default font size Increase font size


  • Aggressive Chemical Concentration
  • Chemical Recycling System
  • Reagent Dilution for Recycle Water
  • Semiconductor/Electronics Process
  • Salinity Adjustment/Desalination
  • Food & Beverage CIP
  • Scrubber/Cooling Water
  • Wastewater Treatment 



  • 96 x 96 mm Inductive Conductivity/Salinity/TDS Transmitter
  • Max. conductivity range up to 2,000mS/cm compatible with an anti-fouling electrodeless conductivity sensor
  • Waterproof and dustproof design
  • User-friendly operation with text and graphic illustrations, clear signs and easy to understand
  • Equipped with CONCENTRATION function for chemical concentration control
  • Built-in chemical concentration curves and a self-defined concentration curve function
  • Simultaneous display of Concentration, compensated conductivity, and absolute conductivity value
  • Smart dual-way communication allows remote control of settings and concentration curves selection
  • Measuring value can be selected for figure or chart display
  • Trace mode can display historical measured value curve from 3-minute to 4-week program
  • Equipped with logbook function and error diagnosis record
  • Large LCM display with auto-sense backlight and contrast setting function
  • Equipped with one analog output and RS-485 interface
  • Automatic temperature compensation with NTC30K, PT-1000
  • Fine tuning of product adjustment function enable process calibration
  • Temperature coefficient compensation by programmable linear and non-liner
  • Hi/Lo, Hi/Hi, Lo/Lo selectable two limited contact output with programmable set-point and hysteresis
  • Gradually continuous sample measurements average function to enhance stability
  • With password and multi-key design—security protection enhancement
  • LED indicated alarms or washing status signal
  • IP 65 (NEMX 4X)


EC-4110-ICON equipped with concentration curve as follows:

NaCl_28%: 0~28%  (Range including different temperature condition)

HCl_18%: 0~18%         HCl_39%: 22~39%

HNO3_30%: 0~30%     HNO3_30%: 35~96%

NaOH_24%: 0~24%,    NaOH_50%: 15~50%

H2SO4_37%: 0~37%    H2SO4_88%: 28~88%, H2SO4_99%: 89~99%

H3PO4_35%: 0~35%

User-Defined Concentration Table(9 temp. x 9 Con./Cond. matrix)

No product information is available.